Centrifugal Blower

These are high efficiency blower ranging 0.25 HP up to 150 HP, capacity up to 1,50,000 M3/Hr. These equipments are manufactured from heavy M.S. or S.S. sheet. Impellers are fabricated following aerodynamic principals either directly mounted on motor shaft or through indirect drive by mounting on shaft.

All products are dynamically balanced as per grade 2.5 of ISO 1940/1-86. Testing of blowers shall be as per code IS-4894. For operating temp. above 150oC shaft shall be either air cooled or water cooled to protect bearings. Vibration transmitted shall be reduced by using suitable vibration isolators. Selection of same is based on total static load, lower vibrating frequency and isolation required.


<< Back





© 2020 Standardaircontrol.com. All rights reserved.